|
CDP 6800 Series Low Flow Booster Pump
|
Distinguishing Features
- Toughest, most durable pump on market
- Adjustable max. outlet psi (regardless of feed pressure)
- Expels trapped air (no more air locks)
- Can be mounted w/pump head up or down
- More flow at extremely low inlet pressures
- New motor venting system to remove moisture
- EMI/RFI electronic noise suppression
- 100% final performance tested.
|
Key Operating Benefits
- Boosts pressure 40 to 120 psi (adjustable)
- Fixed pressure to 160 psi
- Up to 30,000+ operating hours
- Whisper quiet - less than 45 DBA
- Can run dry without damage
- Self-priming - 60" lift
- Low voltage (12-24V) for maximum safety
- Corrosion resistant exterior
- Continuous or intermittent operation
|
Technical Specifications
OPERATION: The 6800 is designed to operate with a PSW Tank Shut-Off Switch for hydro-pneumatic storage systems.
The PSW, when used with a typical under-counter R.O. system, can be augmented with an ESO Electronic Shut-Off Valve.
It is also compatible with most hydraulic shut-off valves.
For counter-top systems, Aquatec's TLC Tank Level Control Switch Valve shut off feed water and the pump when the product water storage tank is full.
POWER: Pumps operate with low energy (only 14 watts), low voltage (12-24 volt) motors, powered with compatible transformers with world wide primary voltages available (100 VAC, 120 VAC, 230 VAC).
Transformers are optional and must be ordered in addition to the pump.
MOUNTING PLATES: The "flexible or steel" base plates are included at no extra cost.
The "Universal" base plate P/N 51-104 is available optionally at additional cost.
FITTINGS: Built-in 1/4" John Guest half cartridge fittings eliminate need for external fittings (unless elbows are required); 1/4" Jaco straight, 1/4" Jaco elbow fittings, or 8mm stem adapters for metric tubing are optionaly available.
INSTALLATION: The location and positioning of the pump may affect its' performance.
Always consult the factory for recommendations that will optimize your system.
|